So if you need to move and stack lots of pallets in a large warehouse environment, you really need a ride on electric
pallet jack to do the job for you. Knowing how to ride an electric rider pallet jack is essential to get started with a pallet
jack. After all, it's not just about lifting heavy things; it's also about safety and technique. So before your next job (or even
before any ride), read this article to learn how to ride a walkie rider pallet jack.
Inspect The Electric Pallet Jack Rider
Inspect your walkie rider pallet truck thoroughly before you take a ride. Check all of the following:
The tires should be in good condition and have no cracks or damage. Should they be balding at any point, this could affect
the weight capacity of your walkie rider pallet truck.
The battery should be charged and tested with a voltmeter or meter to ensure it has enough juice to work correctly during
use.Ensure there are no cracks or signs of corrosion on either side of each wheel, as these can cause severe damage if left
unchecked over time by rusting out completely and causing failure within day!
Double-check both brakes before using this product again--make sure they function correctly without any problems like sticking
pedals or other issues like those mentioned above!
Put On Your Safety Gear
Before you begin, ensure you have all your safety gear on. You'll need a hard hat, safety glasses, steel-toe boots, and earplugs.
And remember to wear a reflective vest or jacket if it's dark outside!
Make Sure The Pallet Is Balanced
The first step is to make sure that the pallet is balanced. This means it should not be too heavy or light but in the middle of
both sides of the forks. Make sure that there are no more than 6 inches between the top of one side and the bottom of another
(or more). If you have much more space than this, put some sandbags on either side to help keep everything evened out.
Next comes putting down some wooden boards on each end so they are sitting evenly across each other and not wobbling
around like a drunken monkey when you're trying to lift things!
Put Your Hand Near The Control Lever
Before you go any further, take a moment to ensure your hand is near the lever. This will
allow you to stop the electric pallet jack rider when necessary and avoid an accident.
Another Hand Hold Onto The Handlebar
Hold onto the handlebar with one hand while keeping your other arm by the control lever (unless you have an injury or
disability that makes it impossible to do so).
If you can't hold onto both sides, lean toward one side so there is less distance between it and where your hand will be
on the electric rider pallet jack. This helps keep things steady but still allows for easy movement if needed.
|